STING GRAY Wrangler JL Club

[supamyk]

Nice! I'll post mine when I get my 35" Tires put on , looks great!

my 35's are being delivered thursday!! so i'll post some pics too!!!!

Sponsored

 

[bdog]

I lifted the Jeep after running stock for three years. AEV 2.5" DualSport Suspension, 4.88 gears, AEV rear bumper and tire carrier, satin black Salta XR' wheels, and 37" BFG KO2's.

 

[Jabarsetti]

There are actually tools to pull it back out in case it does go inside. I want it inside so I can mount my doors on door hangar. Anyone?

I ran with mine in last summer, this way I'll I had to do was unhook the electric and pop the door off. Some 550 cord and a carabiner pops them right back out, it really isn't that hard.

 

[Jabarsetti]

OK Group whos all running polished wheels on their rigs minus the KMC beadlocks. I'm itching for some new wheels, I really like the OEM ones but I don't think they're going to cut it if(when) I move up to 37's. I don't really want black rims. I'm stuck between bronze or polished. but it seams that everyone is getting Bronze or black. Love the red but it's a tad bit loud for my personality.

 

[Irnbru]

2 inch Teraflex lift kit. On 255/80/17 Falken Wildpeak a/t.

 

[KansasJL]

OK Group whos all running polished wheels on their rigs minus the KMC beadlocks. I'm itching for some new wheels, I really like the OEM ones but I don't think they're going to cut it if(when) I move up to 37's. I don't really want black rims. I'm stuck between bronze or polished. but it seams that everyone is getting Bronze or black. Love the red but it's a tad bit loud for my personality.

KMC XD 132. It’s an old picture when I first put them on.

 

[alksion]

Technically it’s the wife’s car. Had her for 7 months. Placing an order for my own as soon as the 2022 models are available. And don’t let the snow fool you. I live in SoCal but the local mountains are close by!

 

[Jhawth]

Picked up my first Jeep yesterday!

 

[Pikdiesel]

Just upgraded to a 2019 JLU! Picked it up with 20K miles.
I had my 2007 JKU since 2011; it had 140K miles on it when driven out of the driveway. It served me well, but time for a newer Jeep.
A 2" Dynatrac Endurosport lift and 35" Toyo Open County A/T's are already on the way.
Let the build begin

 

[Upsidwn]

Bumper and winch installed today

Note to anyone looking at the Arcus bumper, there's no possible way to flip the sway bar motor with this unless you are not running the winch plate. I was hoping there was a way to make it work, but you would need to cut a good portion of the back (radiator) side of the winch plate away for clearance, and then you wouldn't be able to fit a winch anyway.

I'm not a fan of bumpers that stick way out past the front of the jeep, I like them tucked in tight for approach angles and aesthetics, but the winch box is pushed up pretty good against the grill. I wouldn't mind the bumper being pushed an extra inch out to give the winch some breathing room, and allow the sway bar motor to flip.

Things I do like, the bumper's stamped shell seems about as well built as the factory steel bumper.
The winch hoop, while only attached by a few bolts seems more stout than I imagined it would be. I wouldn't dare put a strap or rope to it, but I can lift my body weight up onto it and bounce up and down and it doesn't flex like I thought it would.
The finish and overall quality seem good for the pricepoint.
The rubicon plastic bumper led's fit good. There was no previsions for running the factory led wiring harness over to the driver side fog, so I drilled a few 5/16" holes along the bottom of the bumper and used the push in fasteners on the harness to secure it

 

[seannaz]

My new 4XE....

 

[teacherjeepgirl]

Lift and wheels installed.

 

[SSWIM]

Sam

 

[SoCal]

gotta get the Sting Grays back on the first page, bump....

 

[Boosted.JL]

good choice of wheels! Here’s our Jeep. It’s my wife’s daily driver. She is a paraprofessional at the high school here!

Lift and wheels installed.

Sponsored