lightsout
Well-Known Member
- Thread starter
- #1
Spent the weekend on a few mods on the 4xe.
So far most of the above have not requires much modification to make fit the 4xe, However the Slipstream require alteration of the two floor mounting brackets. The Window Cowl LED Cube brackets also requires cutting and some minor reshaping as the charge port will not allow most if not all of the current brackets to work. Also not the Teraflex Lift is a 1.5" ST1 kit (2" front and 1.5" rear). As you can see any higher would not look right with 35's, in fact I and considering changing my rear to only 1" to eliminate the front rake, however I still have a steel rear bumper coming which like drop the rear a fraction. Yo should also note that a aftermarket bumper and winch will cause the front to sag about 1/2" so you should account for that when you lift. That gap between the tires and the fender flair is exactly 9" on all 4.
Barricade 3/4 Alloy (Aluminum) Series Bumper
Diabolical Slipstream Security Enclosure
Bulletpoint Phone Mount
Thule Pro-2 XTR Bike Rack
EAG Doors
Bestop 2-Piece Fabric Doors
RokBlokz Mud Flaps
Rough Country 30 LED Bar & Auxbeam 4" Side Shooter LED Cubes
Lectron Tesla to J1772 Charging adapter
- Teraflex 1.5" lift
- XD Assault 18x9 wheels with 35 KO2's
- RokBlokz XL Mud Flaps
- Go Rhino Dominator D-6 Slider Removable Drop Steps
- Diabolical Slipstream Security Enclosure
- Barricade 3/4 Alloy Series Bumper
- RC 10,000lb Winch
- 17"LED Bar (bumper)
- 40" LED bar (hood)
- Dual 5" Cubes (window Cowl)
- Rancho Adjustable front/rear Track bars
- Teraflex adjustable front Lower control arms
- RC Spare tire Relocation Bracket
- Painted grill inserts Black
- Rock Slide Engineering Rocker Armor
- Full body 3M Paint Protection Film (PPF) wrap
- Thule Pro 2 XTR Bike Rack
- Bullet Point Phone Mount
So far most of the above have not requires much modification to make fit the 4xe, However the Slipstream require alteration of the two floor mounting brackets. The Window Cowl LED Cube brackets also requires cutting and some minor reshaping as the charge port will not allow most if not all of the current brackets to work. Also not the Teraflex Lift is a 1.5" ST1 kit (2" front and 1.5" rear). As you can see any higher would not look right with 35's, in fact I and considering changing my rear to only 1" to eliminate the front rake, however I still have a steel rear bumper coming which like drop the rear a fraction. Yo should also note that a aftermarket bumper and winch will cause the front to sag about 1/2" so you should account for that when you lift. That gap between the tires and the fender flair is exactly 9" on all 4.
Barricade 3/4 Alloy (Aluminum) Series Bumper
Diabolical Slipstream Security Enclosure
Bulletpoint Phone Mount
Thule Pro-2 XTR Bike Rack
EAG Doors
Bestop 2-Piece Fabric Doors
RokBlokz Mud Flaps
Rough Country 30 LED Bar & Auxbeam 4" Side Shooter LED Cubes
Lectron Tesla to J1772 Charging adapter
Sponsored
Last edited: