Crawldad
Well-Known Member
- Joined
- Mar 4, 2021
- Threads
- 7
- Messages
- 330
- Reaction score
- 394
- Location
- Hagerstown, MD
- Vehicle(s)
- '21 2dr wrangler rubicon, '18 Ram3500
- Thread starter
- #1
i have a couple - three projects going
i want to get wires up to the top of the dash:
1. cb antenna cable (i will need a 1 cm "hole" to get the cable through)
2. power / ground for the cb
3. iphone charging cable
4. a +/- cable going to a 5w solar panel i can use to trickle charge my battery
(i probably won't be using the suction cups lol)
https://www.batterytender.com/Battery-Tender12V-5W-Solar-Battery-Charger-with-Windshield-Mount
oh ok 4 projects lol. anyways, what is the best way to get wires up top. near the center.
my mount will sit in the middle, after pulling out the rubber pad; i can pretty much mount anything to this:
there are two pre-existing screws which the grid will mount to. there are also 3 square holes (smaller than 1 cm) under the rubber pad... i guess i could hog one one of those holes out. unless someone has better advice on getting wires through the dash.
i want to get wires up to the top of the dash:
1. cb antenna cable (i will need a 1 cm "hole" to get the cable through)
2. power / ground for the cb
3. iphone charging cable
4. a +/- cable going to a 5w solar panel i can use to trickle charge my battery
(i probably won't be using the suction cups lol)
https://www.batterytender.com/Battery-Tender12V-5W-Solar-Battery-Charger-with-Windshield-Mount
oh ok 4 projects lol. anyways, what is the best way to get wires up top. near the center.
my mount will sit in the middle, after pulling out the rubber pad; i can pretty much mount anything to this:
there are two pre-existing screws which the grid will mount to. there are also 3 square holes (smaller than 1 cm) under the rubber pad... i guess i could hog one one of those holes out. unless someone has better advice on getting wires through the dash.
Sponsored