Filliat
Active Member
- Thread starter
- #1
Hey guys, long story short i've always thought the idea of a plasma cutter would be badA growing up and now i'm finally have an opportunity i think and would like your opinions.
Locally a guy is selling a 4'x4' plasma table with torch height controller, computer and software. The plasma is a cutmaster 52.
What should i be looking at for tell tale signs of a good entry setup or ways to know to stear clear. Seller is selling for $2500.
I know nothing about this equipment but work in the engineering field where i know of some fab shops we deal with who may be able to help me through some setup issues. I was thinking about calling the fab shops in the morning for there opinion.
I guess at this point it's a novelty in my brain but would love to add it to my collection. i cut all my metal now with angle grinder
Between my garage and my parents (slowly moving all my stuff to new house) i have the following:
mig welder
pro tools 105 bender
29 gallon air compressor
Metal chopsaw and Portaband
Locally a guy is selling a 4'x4' plasma table with torch height controller, computer and software. The plasma is a cutmaster 52.
What should i be looking at for tell tale signs of a good entry setup or ways to know to stear clear. Seller is selling for $2500.
I know nothing about this equipment but work in the engineering field where i know of some fab shops we deal with who may be able to help me through some setup issues. I was thinking about calling the fab shops in the morning for there opinion.
I guess at this point it's a novelty in my brain but would love to add it to my collection. i cut all my metal now with angle grinder
Between my garage and my parents (slowly moving all my stuff to new house) i have the following:
mig welder
pro tools 105 bender
29 gallon air compressor
Metal chopsaw and Portaband
Sponsored